Capabilities
Line 1 is a fully conveyorized powder coating system with full reclaim capabilities and can handle parts up to 10 1/2' long, 34" wide and 58" high. Pretreatment on this line is provided using a three stage iron phosphate spray system.
Line 2 is a batch system used for large parts. This line utilizes an overhead load bar system for parts up to 1,200 lbs. Parts heavier than this are handled on carts. This system uses a spray iron phosphate process for pretreatment. This system is capable of pretreating and finishing parts 26' long, 4.75' wide and 8' tall. If chemical pretreatment is not required, parts 26' long, 5.5' wide, 10.25' tall and weighing 3,000 lbs can be finished. 

Line 3 is a fully conveyorized powder coating system with full reclaim capabilities and can handle parts up to 12'4" long, 34" wide and 60" high. Pretreatment on this system is provided using a five stage iron phosphate spray system. In addition, pretreatment on this system is enhanced for aluminum through the use of a special final seal process. The chemistry in this pretreatment system has achieved salt spray results similar to chromate on aluminum. While achieving good salt spray results, this process is cheaper to operate than chromate and is not environmentally harmful or regulated.

The combination of these three production lines gives Tufcoat significant flexibility in scheduling production runs for our customers. Because of this flexibility, Tufcoat is able to provide rapid turnaround, while still maintaining a very efficient operation. 

Tufcoat's three primary powder coating lines are housed in 50,000 sq. ft. of warehouse space, resulting in ample space to store customer's product indoors, protected in a heated building.